Icom har den 9 April sendt en firmware update til IC9700 på gaden. Download her.

Changes from Version 1.21

• Changed the screen drawing sequence to keep the previous frequency screen layout when exiting from a function displayed in fullscreen.
• Fixed an issue where the standby beep may sound approximately two seconds after receiving a reply when simply pushing PTT to key up the repeater.

Changes from Version 1.22

• Fixed an issue where the DV Gateway function may not work properly when it is turned off and then turned on again.
• Fixed an issue where the RTTY DECODE screen was displayed while leaving the Mark Frequency and Shift Width settings at other than 2125Hz and 170Hz.